Polymer Composite Maintenance Oil

Surface Preparation

The surface must be weathered, cleaned, dry and frost-free. Osmo Polymer Composite Maintenance Oil is ready to use. Do not thin. Stir well. Prior to application, the surface must be thoroughly cleaned with Osmo Polymer Composite Cleaner 8021. This ensures sufficient bonding. Before applying Osmo Polymer Composite Maintenance Oil, rinse thoroughly with

water and allow to dry.

Method of Application

With Osmo Flat Brush or Osmo Decking Brush, apply very thinly and spread well. Remove excess material (pooling or streaks) with a clean dry Osmo Decking Brush. Important: the liquid oil must be absorbed into the surface. There must not be any oil remaining on the surface or in grooves. Excess oil dries very slowly and produces a glossy oil layer without sufficient adhesion to the substrate. Leave to dry for 8-10 hours. Ventilate well while drying.

Note

Oils enhance the natural colour of the substrate (permanent wet effect). Trial application is required! Impregnation may influence the slip resistance of the

original surface. White or very light-coloured surfaces may become slightly yellow from oiling! Non-absorbent surfaces, such as glass, glazed tiles, ceramic or plastic, must be not treated (impregnated).

Download the PDF product information and safety data here:

Product Information

Safety Data

Top Tips:

• Apply very thinly and spread well
• Always the test for compatibility with each surface.
• Do not thin product.
• Use only outdoors or in a well-ventilated area.

Additional Information:

• Product code: 030
• Approx. coverage : 40m²/L
• Sizes: 1L, 5L