Surface Preparation
Wood surface must be clean, dry and frost-free (moisture content max. 18%).
Osmo Polyx®-Oil Express is ready to use, please do not thin. Stir well using a flat stirring stick or spatula before use. Failure to mix all ingredients ( and colour) could lead to an increased patchiness.
Clean old microporous stains thoroughly. Old paints and lacquers must be completely removed. As a general rule, wear a dust mask during sanding works.
Fill small cracks, larger joints or holes in wood (with Osmo Wood Filler).
Sand wood surfaces carefully. Begin with coarse sandpaper – final sanding work for flooring P120-150, for furniture P180-240. Before oiling the surface, remove sanding dust with a broom or vacuum.
The finished surface is influenced by several factors, including the wood‘s natural characteristics. Therefore, a trial application is always required, especially for unfamiliar surfaces.
Method of Application
Apply thinly along the wood grain with Osmo Natural Bristle Brush or Osmo Microfibre Roller and spread well within 10 minutes. Avoid excess product.
Leave to dry for approx. 2-3 hours with good ventilation. After drying, carry out second coat as stated above. Avoid covering during drying and curing. After 2-3 weeks, the surface is fully cured.
When renovating or recoating an already oiled surface, one coat applied to the clean and dry surface is usually sufficient.
Note
Applications with the Hardener for Polyx®-Oil Express 6632 as drying accelerator are also possible as an option. Please observe the instructions for a correct application.
Oils enhance the natural wood tone (permenent wet effect). Applying the product too generously and insufficient ventilation lead to delays in drying time and the typical smell of oil.
For dark and extractive-rich hardwoods (e.g. Wenge, Merbau, Jatoba etc.), we recommend using Osmo Wood Wax Finish Clear Extra Thin. A trial application is recommended.
For cork surfaces, due to their high absorbency please ensure that the wood finish is applied especially thinly. On cork, longer drying times are to be taken into consideration (at least 6-8 hours).
Caution: Apply max. one coat thinly to cabinet interiors and drawers with a cloth.
If a higher gloss level is desired use Osmo Liquid Wax Cleaner very thinly and polish when dry. Avoid using Osmo Liquid Wax Cleaner on surfaces that have not dried and cured properly. Always trial apply first.
Using general or multi-purpose cleaners will increase the frequency of maintenance and recoating. Allow finish to fully cure before heavy usage.
Care
Regular Cleaning: Wood surfaces treated with Polyx®-Oil Express are highly repellent and easy to maintain. Remove debris with the Osmo green Dust-Mop from the Mop Cleaning Kit for Floors, or use a broom or vacuum cleaner.Damp mop floors using diluted Osmo Wash and Care and the Osmo Micro-Mop Plush from the Mop Cleaning Kit for Floors. Avoid saturating the surface with water. For the convenient cleaning of floors use Osmo Spray-Mop. For furniture or small areas, use Osmo Spray Cleaner and Osmo Easy Pads.
Occasional Maintenance: For spot cleaning stubborn scuff marks, or occasionally refreshing satin or gloss Polyx-Oils use Osmo Liquid Wax Cleaner. Alternatively, Osmo Maintenance Oils can be used to occasionally refresh most Polyx Oil sheen levels, including matt. Ensure surfaces are appropriately cleaned before thinly applying Osmo Maintenance Oils.
Recoating:
Simply re-apply one coat onto the appropriately cleaned and dried surface when signs of wear become visible.
